When using pressure sensors, the output signals 0 ? 20 mA, 4 ? 20 mA and DC 0 ? Venomous are generally chosen to ensure that the sensor signals to be evaluated and further processed. Because of this, the signal output of the pressure sensor is usually linked to a corresponding input card in the PLC.
In this context it could often be confusing, as the day-to-day using the terms ?active?, ?passive?, ?current source?, ?voltage source?, ?current sink? and ?load? are often wildly mixed together. Any electrical signal processing always takes a voltage supply (an ?active part?) and a ?load?, such as a pressure sensor, which represents the ?passive part?. Sometimes the active portion of the interconnection is also described as a power source/voltage source and the passive part is known as a ?current sink?. In Crave that an electrical circuit can function, current must flow in a circuit ? even when an instrument is usually known as lots, the current is not consumed because of it, rather it only flows from the current or voltage source through the load and back to the current source.
Antagonistic works only if an ?energy gap? exists between current source and current sink, therefore the power source operates actively (= sending out current) and the current sink passively (= current flows through it) . Therefore, an interconnection of two current sources or two current sinks will not operate normally. This example is complicated in day-to-day application:
When does a pressure sensor work passively (current sink) and when does it work actively (current source)?
How does the input card in my own PLC operate?
Generally of thumb, one can remember that 2-wire sensors usually work passively and therefore need a dynamic PLC input card. It is difficult with 4-wire sensors, since, for instance, a 4-wire flow sensor includes 2 wires for another voltage supply and 2 wires for an active or passive 0/4 ? 20 mA signal output. It is therefore imperative to check the datasheets for the sensor and PLC input card used.